Rock climbing holds, Wave collection

For all my climbing hold prints, I've primarily used PETG, which works best when it's dry at 0.16 layer and 2-5 fuzziness. ABS is a good alternative. I’ve also tried PLA, which performs well indoors as long as you’re not too heavy and avoid dynamic moves. Avoid overtightening the holds, and use a washer when necessary.

I design 3D-printed climbing holds in Bambu Studio. Using AI to transform a vase into rock climbing holds with 

Make My Vase in MakerLab.

This set is crafted for Beginner to intermediate climbers.

For harder holds, check out my other projects designed for experienced climbers.

https://makerworld.com/en/models/1561758-realistic-rock-climbing-holds#profileId-1641388

This 3D-printed climbing hold is provided without guarantees of print quality or structural integrity. Always inspect holds before use.

• Use a washer with the mounting hardware to ensure proper installation.
• Do not overtighten, especially on the double jug, as this may compress the central shaft under the bolt.
• Avoid excessive sideways pulling, as it may cause the hold to rotate under certain loads.
  • Please use the screw version for the double jug if it is not intended to be used by kids.

Crush it safely!

Fasteners dimension

Wood screw # 8

Bolt Dimensions: 3/8-16 Allen Head Socket Cap Screws

Flat Head Socket Cap Bolt - Stainless Steel - 3/8", 16

Nominal Diameter: 9.525 mm (3/8 inch)

Washer Dimensions: SAE Flat Washers 3/8"

Inside Diameter: 10 mm

Outside Diameter: 21 mm

Thickness: 2 mm

Stay tuned for More kid-friendly climbing holds with fun and safe designs, coming soon!