Search models, users, collections, and posts
Jet Engine stand with non-slip
Remixed by
IP Report
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
4 h
3 plates
0.2mm layer, 2 walls, 15% infill
5.2 h
4 plates
0.2mm layer, 3 walls, 15% infill
13.3 h
3 plates
0.2mm layer, 2 walls, 12% infill
5.2 h
3 plates
Open in Bambu Studio
Boost
285
587
106
93
1.2 k
686
Released
Description
I modified yohann LEFEUVRE design by adding TPU to the Patins (Pads) so that the Jet engine sitting on there would not slip easily when you are rotating the compressor. THe original design was good but did not hold the jet engine well when fidgeting with it. The whole jet engine would slip and roll on you. By printing a TPU pad and gluing on the Patin, it greatly helps preventing any unwanted movements.
UPDATE 04/18/25: If you plan to add a motor and have the turbine turn, I have designed a stand for a motorized Turbine.
https://makerworld.com/en/models/1334409-jet-engine-motorized-stand-with-non-slip#profileId-1373424
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (106)