Search models, users, collections, and posts
AMS 2 Pro Small Spool Adapter
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
143
494
60
6
576
467
Released
Description
An adapter allowing your to use spools that are usually too small for the AMS 2 pro system.
All credits to @eclipsecustoms
Min spool width requierments: 4.5cm
Min spool diameter 16cm (to be confirmed)
Print in PETG or don't let in the dryer.
Instructions:
Pull the roller out. It might be firmly attached.
Put the adapter in.
Put the roller in the adapter.
Update v1.1 (22/07/2025):
The bearings were falling appart sometimes, so I added some walls. I also increased the guide.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (60)