Search models, users, collections, and posts
Redcat Ascent-18 Trailer Hitch Assembly
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 100% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
37
79
2
0
92
52
Released
Description
This hitch/receiver assembly was designed for the Redcat Ascent 18 trailer for pulling a trailer.
INSTALLATION: Remove existing screws from the truck frame, put the receiver in place, and reinstall the original bolts. No modifications to the truck are needed. The hitch is attached by a standard RC body pin.
I printed with ASA, but do not see any reason you cannot print with PLA.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)