Multicolor Majora's Mask - Single AMS Version

I wanted to print 3Dprintdogs Multicolor Majora's Mask, but I only own a single AMS. So this is another remix of WeeMadSausage's excellent woodgrain Majora's Mask sculpt but split up and completely repainted in BambuLab so that each part requires a maximum of four colors.

Since the model had to be modified, all the painting had to be re-done, but I tried to match 3Dprintdog's version as much as possible since it's so beautiful.

It prints on five plates. Because the horns are separated, I could increase the size slightly so it's about 10% bigger than 3Dprintdogs version.

Some of the parts, especially the pupils and runes, are quite a tight fit but on a BambuLab printer the tolerances should be good enough to fit with a bit of a push (make sure you align the eyes and pupils correctly as there's no getting them back out). The horns require gluing onto the body. I had some issues with the base of the supports overlapping the body in places, which required a bit of trimming but wasn't an issue.

Colors for the print in the photos:

• BambuLab Matte Scarlet Red
• BambuLab Matte Mandarin Orange
• BambuLab Matte Lemon Yellow
• BambuLab Matte Apple Green
• BambuLab Matte Marine Blue
• BambuLab Matte Charcoal
• BambuLab Matte Ivory White
• BambuLab Basic Gold 
• BambuLab Basic Purple

For wall mounting I made a bare-bones hook with screw holes, but Timerio has made a nice looking one (https://makerworld.com/en/models/2222537-majoras-mask-wall-stand#profileId-2419768) I can't vouch for this myself but looks like it should work!