iPad and Foldable Phone Stand
Print Profile(2)
Description
Print-in-place. Features a minimalist design inspired by the new Mac aesthetic. Primarily addresses the height and angle requirements of iPads, tablets, and foldable phones.
Height: The iPad sits approximately 9cm above the desk, effectively preventing neck strain from looking down while watching videos.
Angle: Near-vertical angle relative to the desk, enhancing viewing experience.
Two presets are available
Sturdy Preset: Employs 4 walls and 20% infill, suitable for most tablets on the market. (Recommended Print Setting)
Quick Print Preset: Uses standard 2 walls and 20% infill. The stand may exhibit slight wobble when holding tablets larger than 12 inches; proceed only if acceptable. I used this preset to save material, and the wobble is acceptable for me. For optimal stability, the sturdy preset is recommended. Suitable for smaller tablets and as a foldable phone stand.
Foldable phone usage shown below
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (104)