Shuriken Launcher

This model does not require any supports to print- and is entirely 3d printed with the acceptation of the rubber bands. Print and snap the parts together to build yourself a shuriken launcher to help deter unwanted ninjas.

Printing some targets is also recommended

 Assembly:

1 - Slide the slider into the bottom half of the shell

2 - Put the gear into the pin, and follow it with the spacer

3 - Slide the pin all the way into the slider

4 - Put 4 snapping joints into the 4 holes onto of the shell

5 - Press the top shell onto the bottom shell

6 - Add 2 snapping joints into the top shell

7 - Snap the ramp on top of the upper shell

8 - Attach 2-4 rubber bands as shown below

9 - Enjoy AND DON'T SHOOT PEOPLE (Unless you are defending from ninjas)

Loading:

1. Pull the slider back slightly so that the gears pins are above the ramp
2. Put the shuriken on while holding the slider back with your thumb
3. Ensure the shuriken has pins fully in all 3 holes, failure to do so can make the shuriken move unpredictably 
4. Pull back
5. Fire

Warning

This is a toy and can be dangerous if misused, please ensure you never point this at something that can be damaged and ensure it is correctly loaded before you fire it, never aim at people.