Lumena FAN PRIME3 Upper adapter

This accessory is designed for the Lumena FAN PRIME 3 cordless fan. It's created to address some of the fan's shortcomings. (Alas, there's no solution for its weak neck!)

Its functions are as follows:

• Elevates the fan to approximately 13-14 cm.
• Provides stable support with four legs.
• Features an attachable/detachable compartment for cabling or a portable battery.

Caution: This design necessitates the use of support filament. While you can attempt using regular filament for support, the intended results aren't guaranteed.
 

The design's speed settings are optimized for quieter operation, allowing for nighttime printing without compromising output. This setting can significantly reduce print times in speed mode.

Using a 0.6mm nozzle can further decrease printing time.

*Use with other Lumena models or third-party fans is not guaranteed.

For those wishing to create derivative models, the inner diameter of the fan's bottom mount is provided.

Measurements are based on Blender; you will need to convert them. 1m (Blender) = 10mm = 1cm

Example: 16.23m (Blender) = 162.3mm (actual length)