Search models, users, collections, and posts
9mm Snap Cap Inserts
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
6.1 h
2 plates
0.2mm layer, 2 walls, 15% infill
Designer
3.3 h
2 plates
Open in Bambu Studio
Boost
136
447
25
4
523
263
Released
Description
Take some used 9mm brass and insert these into it. These require spent brass casings.
Any material works, I just used PETG because I had a lot of it in bright red.
When inserting these into brass, consider using a hammer to the backside of the brass to make sure they're seated properly, maybe use an adhesive if you want to make sure they don't fall out.
Boost Me (for free)
Support 3D2A
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (25)