Slim 6 Wallet

This wallet uses only printed parts and raw filament. It fits up to 6 cards, is just 7.6mm thick, and is 100% fully printed. No hardware or fasteners. I prototyped and tested all prints in ABS and ASA, but other filaments should work fine as well. For retaining the cards, insert a strand of filament in the two holes at the top of the wallet. You can use any filament type for this but if you use a rigid filament and it's too tight, you could replace one or both with TPU. A little tight is better as it will likely wear in over time. I used white filament to make it easier to see for the photos, but you can match the wallet body or choose a color to accent (maybe the same color as the ejector?).