Search models, users, collections, and posts
Bottle Cap to Air Tube Connector
IP Report
Print Profile(1)
0.16mm layer, 3 walls, 100% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
28
60
0
2
58
39
Released
Description
Content has been automatically translated.
- Bottle Cap to Air Tube Connector (A must-have for DIY enthusiasts)
- Can be used to connect plastic bottles (common beverage bottles on the market, such as cola bottles) to air tubes and other plastic tubes (Note: Silicone tubes cannot be used)
- Air tube connection size: 6mm outer diameter, 4mm inner diameter
- Bottle cap, single-head, double-head, and triple-head options available (select during printing)
- Excellent quality, comparable to commercially available plastic adapters. 100% infill and multi-parameter adjustments ensure good pressure resistance and water tightness (with sealing ring), suitable for short-term use.
- Can be printed using any mode (printing one in "狂暴模式" takes only 28 minutes). Printing a single piece requires only 12g of filament. PLA or PETG filament can be used.
- For increased sealing, a rubber sealing ring can be purchased; it is very inexpensive. Sealing ring size: 28mm outer diameter, 3.1mm wire diameter Installation: Simply use a flat object to press it into the groove.
- Feel free to point out any areas for improvement. Happy printing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)