Search models, users, collections, and posts
Battery powered IR Head Tracker
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
57 min
1 plate
Open in Bambu Studio
Boost
4
11
3
0
16
8
Released
Description
AA Battery powered version of a Track IR Clip.
The switch is superglued to the frame.
Materials required:
-Wire
-switch (clip off one of the contacts on the side)
-30 Ohm resistor (yours depends the voltage of your LEDs. check out an online resistor
calculator for parallel circuit LEDs)
-IR LEDs of your choice. (mine are 1,5V 20mA)
-velcro for the back or some rubber bands to attach it to your headset
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)