Expedition 33 Keychain .2 Nozzle
Print Profile(2)
Description
Know that this can only be printed with a .2 nozzle. If you want to print a similar keychain with a .4 nozzle, you can find it here: https://makerworld.com/en/models/1640406-expedition-33-keychain-4mm#profileId-1733218
You could print this model with a .4 if you make it 100% bigger. But that is not recommended.
This print also has some assembly mid print. At about the halfway point you need to remove the back from the build plate and place it firmly into the empty space of the second part. As shown in the following pictures.
Be sure that it is placed face down and firmly pushed into place. It is OK if it is sticking out a little bit. Especially at the bottom. The Printer should push it in place as it prints over it. Once it is in place press play. You may want to watch it lay down the first layer, just in case it pops out.
Boost Me (for free)
If you like my work, please leave a boost!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)