LED Christmas Tree Set XMAS Tree Autumn Tree

Hello my dears,

I've experimented a little and this is what came out

Two trees in a spiral design with grain

An LED wire light chain with two batteries is required as a light source (not a three-battery version)

I used a wire light chain with a timer

It's not a simple, quickly assembled print

The supports (see pictures) were easy to remove in my opinion

I took some time for it (5-10 min) to make it decent

I reworked the surface where the supports were with sandpaper (see pictures)

As a tool I used craft wire with a diameter of 2 mm (large tree)

and 1.5 mm diameter (small tree)

It's a bit tricky to find the right wire that's not too strong but not too soft either.

I inserted the wire at the tip so that I could pull the LED light chain through (see pictures)

After that I put the LED wire light chain into the battery compartment, pulled it through the trunk, then through the

adapter, attached it to the craft wire and then pulled it through the spiral

I shortened the LED wire light chain and put everything together.

You can see the course of the LED wire light chain in the attached PDF

But again, it's NOT done in a moment, you have to do some rework and fiddle the wire through the spiral,

but you get a very nice result, in my opinion

So please don't complain because you have to rework, otherwise please DON'T print and therefore

rate it poorly. Thank you

Size:

large tree height approx. 27.5 cm (diameter approx. 12.5 cm)

small tree height approx. 24 cm (diameter approx. 10.7 cm)

If you like my model, please leave a like

If you like my work, please support me with a boost

Have fun printing and many thanks to you all

Please don't forget to rate the print profiles. Thank you very much

Here is my Instagram Account

https://www.instagram.com/kann_nix_printdesign?igsh=djdrN2p3NXUxbW9t&utm_source=qr

Check back regularly, I will regularly post previews of new prints there

Thank you very much for your support

and have fun printing