Remix Disposable Floor Drain Filter Screen (single-piece print, ultralight and ultrathin, more durable!)

Please read the following description before printing:

I. Design Intent:

1. As shown below: An ordinary thin mesh filter appears to have a large area, but in reality, because the edges lie flat on the drain, water can only flow through the center. Hair collects in the central 20% area. After replacing it with a new one, the center clogs up after a few days, and water flow becomes poor. Frequent replacement is troublesome

2. As shown below: To solve the above problem & to facilitate printing, a filter with deployable support legs was designed. Water can flow down from all sides, allowing the entire filter to function effectively

II. How to Use:

Note: After printing is complete, the upward-facing side is the front, and the downward-facing side is the back

1. Take the 'T'-shaped support leg, bend it backward from the base, then bend it again from the middle, so that the crossbar passes through the hole shown in the image below, forming a support leg

2. Fold all four support legs

3. Bend the 'J'-shaped hook in the middle forward towards the front side, and hook them together to form a handle for easy replacement

4. Place it on the drain and it's ready to use

III. Important Notes:

1. Please print with PETG

2. The current diameter is 75mm. If you need other sizes, please leave a message to contact me