Search models, users, collections, and posts
Simple Filament Rack for 1 Inch Wood Dowels
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 5% infill
Designer
8.9 h
2 plates
Open in Bambu Studio
Boost
11
42
8
3
72
34
Released
Description
For US makers, you can build this with 1 inch dowels cut to length. Print 4 of each part and assemble.
Depending on dowel tolerances, you may need to sand the ends a bit to fit. Consider also adjusting X-Y hole compensation to make the holes a bit larger in diameter.
Bottom corners have feet, but these are not necessary. You could just print 8 top corners.
Recommended cut lengths: 10 in for vertical dowels, 3.5 inches for depth dowels, and 24+ in for width. Make as long as you want. Each hole is 1 inch deep, so account for that.
Print materials and settings are totally flexible. I don't think this needs more than like 5-10% infill but I would suggest slightly thicker walls.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (8)