x1c ptfe side saver
Print Profile(6)
Description
Tired of having your ptfe catch and be chewed up on the inside of your printer? Or tired of hearing your cable chain smack the lip? Not a problem anymore! print this in pteg minimum recommended, abs / asa preferred. glue / press fit your choice of 10x3mm , 8x3mm , 6x3mm, or .5" x .125" magnet when done. you may have to trim a small bit of the foam tape hiding a screw for it to fit snuggly. bigger magnets preferred as well. my .5" ones haven't moved on me in nearly 100 hours. works without a riser just fine, clearance to be used with top glass in place.
when used in combination with https://makerworld.com/en/models/15497#profileId-15284 I've had no retraction issues and my ptfe doesnt rub against the glass. only other mod i have is the smoothy y splitter to feed from my dryer https://makerworld.com/en/models/18174#profileId-17021
K.I.S.S!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (29)