Search models, users, collections, and posts
Gloomhaven / Frosthaven Ability Card Holder
Remixed by
IP Report
Print Profile(2)
0.4mm layer, 2 walls, 15% infill gyroid, no supports
Designer
3.4 h
1 plate
0.4mm layer, 2 walls, 15% infill gyroid, no supports 4 pack
Designer
12.3 h
1 plate
Open in Bambu Studio
Boost
12
54
0
0
58
30
Released
Bill of Materials
Bambu Filaments
Select all
Description
This is an updated model of mosjef's excellent Player Ability cardholder for Gloomhaven and Frosthaven.
I updated the original to include a spot for the players damage deck. It's a nice little accessory you can print in a couple hours that helps you control the chaos that is a good game of Frosthaven! Print one for each of your players.
I printed mine in Marine Blue with a .4 nozzle at .20 layer height with about 15% gyroid infill. Adjust as needed. The model does not need supports.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)