benchy in bottle

Benchy in a glass!
 

A fun little project for testing transparent filament.

For the best results, use the Arachne wall generator for the glass.

There’s a pause in the G-code at 61 mm — that’s when you need to insert the Benchy.

I found that a 0.24 mm layer height worked best for me, but it may vary depending on the filament.
I used Filament PM transparent petg.

There’s also a similar version designed for small figurines.
https://makerworld.com/en/models/1419102-figure-in-glass#profileId-1474104