ANBERNIC RG 35XXPro Clip-on Cover

Intended to reuse the foam insert that ships with the device, I wanted something that would protect the screen and the sticks but wouldn't be too bulky or require a lot of unclasping. A simple cover that clips onto the front of the device, glue the foam insert to the bottom to add cushioning for the front, and slide in. If you no longer have the foam insert, I included a thicker version with cutouts to house the buttons, but I'm not sure if it might scratch the screen if used long term.

Should clip in easily but if the fit is too loose or too tight I recommend softening the clip part at the back with a hair dryer or heat gun, then sliding in the device and holding the clip part down so it hardens in perfect profile.

Because I lack an AMS I added a pause on layers 2 and 5 to manually swap to a different colored filament so that the design on the front shows through. However, I've also included print profiles that use the AMS if you have one.