Decorative Design Scandi Lamp - LED Kit MH001

Decorative Design Lamp in Scandi Style

The lamp parts are easy to print and assemble (without screws etc.)

You need the LED Kit MH001

Please read the assembly instructions or watch the assembly video 🛠

Printed Parts:

1. Stand
2. Cable Cover
3. Stand-Stick
4. Top-Mount
5. Shade (use translucent filament)

6. Cap (optional)

    

   

Part 6 “Cap” does not need to be printed. It is optional or a matter of taste

Dimensions of the finished lamp

• 235 mm (height)
• 154 mm (widest point)

Assembly:

Step 1: Base and Rod

Part 3 (Stand-Stick) is screwed into Part 1 (Stand).

Part 2 (Cable-Cover) is pushed over Part 3 from above, so that the cable is covered later.

Step 2: Top-Mount and LED

Part 4 (Top-Mount) is screwed onto Part 3 from above.

The LED board (Image 3) is inserted into Part 4 from above.

The cable is threaded through the opening in the Top-Mount, runs internally down through Part 3, and exits laterally at the Stand.

Step 3: Lampshade

Part 5 (Shade) is placed onto Part 4 from above. (Outer recess)

Optionally, Part 6 (Cap) can be placed on top of Part 5 to close the lamp.

The support fits tightly, but can be easily removed:

If you feed the cable through the Top-Mount and the Stick (and Cable-Cover), the switch will only fit through the hole with the back side facing up:

If you wish, you can glue soft glides under the lamp. Recesses are present in the base: ◯ 20 mm

The lamp provides a very nice ambient light to the room!

Have fun with it :)