Protective Flower - Lens Accessory

This flower is here to protect your lens and give it a beautiful addition!

Instructions:

• Print the two parts Flower and Seeds separately with different colors (The Flower has to be TPU), put just a little of glue on the back of the Seeds, and place it on top of the flower. Wipe the extra glue if it comes out.
• You can decide to print just the flower if you want.
• Wait for the glue to dry before placing on your lens, the glue can get to your lens otherwise.
• After drying, you can break the small connections in the seeds to allow the part to stretch.
• I have placed every part on a separate plate and named the plate, I hope that makes it easy to choose what to print.

Lens sizes:

I have provided a couple of sizes in different plates, if you want another size you can scale the STLs provided.

The original STLs are for a 67mm lens

So if you want a 55 mm for example: (55/67)x100 = 82.09%

The provided sizes are: 67, 58, 72, 52, 49, 46 mm . The last 4 sizes were requested by some of you in my previous models.

If you don't like the fit of your printed part, scale up or down and print again.

Print settings:

• I have sliced for TPU using SpicyElephant's “Perfect TPU Print Settings” .
• I used Bambu TPU 95A HF.
• The seeds are basic PLA, Fuzzy skin 0.3 mm, Activate Detect Thin Wall  to print the connection between the parts.
• I used Adaptive layer height to have smaller layer height in the important areas.
• No support is needed.

What should I make next?