The "Fun" Button (Confetti Cannon) - No Glue
Print Profile(2)
Description
Sitting at a desk all day? Has life got you down? Fear not, for the “FUN” button is here! With a swift smack of the button, your worries will fade away for just a while! (You'll be focused on cleaning the mess for the time being)
- AMS is only used for the lettering and is optional
- The fun button is just a simple confetti cannon
- It takes 7 - 14 mm confetti (you may cut these out yourself or even use hole punch waste)
- Printer poop works too, but may need to sift for smaller pieces.
Assembly Instructions
 | Step 1: Print and gather your parts. |
 | Step 2: Insert spring. |
 | Step 3: Insert button. (take note of orientation) |
 | Step 4: Place cover. |
 | Step 5.1: Insert body clip as shown. |
 | Step 5.2: Apply pressure to one side of the clip to seat. |
 | Step 5.3: Apply pressure to the corner, causing the other side to stickout a little (circled in blue) |
 | Step 5.4: Press the side sticking out until it “clicks” or is flush to the body |
 | Step 6: Repeat untill all clips are seated |
 | Step 7: Cut 7- 12mm squares of paper or use a hole punch for circular confetti (I did not have any coloured paper) |
 | Step 8: Funnel paper into hole as shown and Smash the button to enjoy! |
Boost Me (for free)
Boosting Helps A Lot!
Membership
Commercial Licenses Available
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (11)