Lazy Susan Storage Bins Using Bambu Lab Spools
Print Profile(1)
Bill of Materials
- Empty Bambu Lab Spool x 1: One required for each layer
Description
Boost Me (for free)
"You can do it!" -- Rob Schneider
Reuse those Bambu Lab spools into a useful and expandable storage system! The only other hardware needed is one 608-2RS or equivalent size bearing for each spool. There are three bin variations. A smooth bin front, a hex pattern bin front and a label holder front. All of them have a removable divider. The label holder is sized for an approximately 20x100mm paper/card stock label.
Bearing Dimensions
Assembly Instructions
|  |
| 2. Install the Spacer over the Stand and Peg. |  |
| 3. Remove support from the Lower Pivot and then press in a bearing. |  |
| 4. Remove support from the Bin Base. Install the Base and Lower Pivot onto the lower half of the spool. Align one of the notches in the Base with the core peg on the spool. |  |
| 5. Remove support from the bottom of the Bin. Align the dovetailed slot with a corresponding dovetail guide on the Base and slide on. Then install the top half of the spool. Place the assembled spool onto the Stand. |  |
| 6. Install a Peg into the Lower Pivot. (Remove any support from the Peg hole first.) |  |
| 7. Install the Lower Pivot onto the spool top. |  |
| 8. Repeat steps 3 through 7 for each additional layer. |
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (20)