Search models, users, collections, and posts
Honda Del Sol Upper Tail Light Panel Clip
IP Report
Print Profile(1)
0.24mm layer, 4 walls, 60% infill
Designer
28 min
1 plate
Open in Bambu Studio
Boost
23
61
4
0
51
40
Released
Description
This is a model of the center clip on the upper tail light panel of the Honda del sol that has been discontinued (not for the tail light itself but for the body panel that holds the upper tail light). I haven't tested the fitment yet because mine isn't broken but I got the measurements from the oem clip so it should fit good, if anything needs adjusted on it just let me know.
PRINT SETTINGS
PETG or better strength recommended
.24 layer height gives better layer adhesion
Supports needed, I recommend printing the clip on its side so that the flexible part of the clip has the best strength
If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (4)