Stand for Toothpaste V3.0

Excited to introduce the third version of the toothpaste stand.

Over the years, my skills have grown, and the print quality has improved. Modern printers are much more precise and allow for printing non-disassembled designs with movable parts. As a result, after several prototypes, I've created a fully functional stand that prints in one go and requires no supports.

In this version, I fixed the errors from the previous one and, upon numerous requests, added a gear mechanism to prevent the toothpaste from rolling back.

There are many similar stands out there, but I settled on this one for several reasons. Perhaps the main one is the ability to always place the toothpaste vertically. It takes up less space and is much more convenient to use.

With the gear mechanism, the toothpaste is always neatly tightened, allowing it to stand upright without leaning.

I printed several of these stands in PLA Matte plastic, and the result turned out very good.

Please note that there are two variants of the wand and you can choose which variant you prefer.

It turns out that a lot of people don't know how to properly tuck toothpaste into a toothpaste holder. Here are some photos that clearly show it.

And also I would like to tell you that I recently started a small store on Etsy.com here will appear instrementy and exclusive projects that will not be in the open access.

If you would like to express your gratitude you can do so here.

Link to version 5.0

Also, a project Organizer for Philips Sonicare toothbrushes. has recently appeared, which you can find at this link.

And also don't forget to check out other projects you might like: