Search models, users, collections, and posts
Starlink cable management
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
4.5 h
1 plate
Open in Bambu Studio
Boost
12
45
1
1
52
21
Released
Description
I installed Starlink outside the house, and printed parts I designed to be printed in TPU
- a passthru to pass the cable fru the wall. I had an area with a 20 mmm wood plate. I did a 40 mm hole into the wood. That is requred to pass the cable with its connector. The passthru is printed in two parts, and will just let the cable go thru.
- some cable retainers, designed for the Starlink cable (8mm diameter) and 2mm diameter nails. I've printed 10 initially, but added 10 additional one in the slice profile as I found 10 to be too short in my case :)
Both parts can be printed without supports. I printed them in TPU.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)