Search models, users, collections, and posts
Adapter PC4-10 to PC4-6 for Side Mount Spooler
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
3
2
0
0
2
1
Released
Description
A small addition to the Side Mount Spooler of Codebender and/or for its remix by TheMiguelBi.
The original models require a PC4-M10 connector. Which I didn't have. This adapter allows to use PC4-M6. Its size corresponds to the hole in the arm and it has M6 threads on both sides. You can use both sides to install the connector, or just one (see photo).
Less than two grams of filament, approx. 15 minutes of printing.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)