Search models, users, collections, and posts
Support for Disney figures
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
35 min
1 plate
Open in Bambu Studio
Boost
15
23
0
0
14
3
Released
Description
Content has been automatically translated.
Print without supports
4 to 6 walls are suggested.
PLA is sufficient
In the file you will find 5 different sizes from 3.5mm to 5.5mm.
A 3M drywall screw is required for drywall, or a very thin double-sided tape, ideally 3M, can be used. If it's for a wall, the corresponding installation must be done.
If this has been useful to you, I'm leaving my Buy Me a Coffee link in case you're interested in making a donation so I can continue designing and uploading useful resources like these for free! https://buymeacoffee.com/chitopolo
Boost Me (for free)
I designed these ultra-light and simple supports to organize my Star Wars figure collection; quite useful and cost-effective. I hope it helps you and I hope you can give me a boost!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)