Frosthaven Bannerspear banners, pre-supported

I was not satisfied with the generated or SLA supports on these models, so I decided to give it a go at making the banner bottom edge as good as possible. I have noticed that 0.15mm thick walls are easy to remove with a hobby knife even when they are part of the model (unlike usual supports that have a gap), so I have added these under the banner curve.

I also re-meshed the banner of courage so that is has rounded shapes on the cloth similar to the other banners.

I included the base I've used with added shape of the banner model. Unless you print the banners on smooth plate and sand the top of the base, there will be a visible gap (why I drowned it in AK Snow).

When you're removing the wall supports, make sure you do not slide your knife against layer lines as it is easy to split them. Similarly, be very careful with precision pliers, it does not take much to break the more fragile parts.