Adjustable Angle Heat Set Insert Press

Under 60 yuan, you can get an adjustable angle heat set insert press!

This is an adjustable angle precision DIY heat set insert press

Features:

• Quick-release soldering iron mount without other tools—simply twist 2 thumb nuts to remove the soldering iron in seconds

• Adjust the angle by simply pulling out one spring-loaded pin, making it easier to heat set inserts into angled workpieces

• 300mm MGN9H linear rail combines lightweight design with professional-grade precision

• No expensive components needed, just a few screws for assembly after printing the parts to achieve professional results

BOM List:

Button head hex screw M4*16 1 pc (for connecting fixed column and movable column, do not tighten too much, movable column needs to rotate freely)

Button head hex screw M4*10 2 pcs (for fixing both ends of the tension spring)

Button head hex screw M3*35 2 pcs (for soldering iron fixation)

Button head hex screw M3*8 12 pcs (for fixing crossbeam to linear rail, and linear rail to movable column)

Button head hex screw M3*14 2 pcs (for connecting fixed column to base)

Thumb screw 25#4*16 1 pc (angle adjustment screw)

Tension spring wire diameter 0.5*outer 5*length 50 1 pc

Thumb nut Through-hole M3 2 pcs (used with 2 M3*35 screws)

Lock nut M4 2 pcs (used with 25#4*16 thumb screw and M4*16 button head hex screw; available in packs of 10, buy 1 pack)

Slider MGN9H extended 1 pc

Linear rail MGN9H 30cm

Linear rail limit stop MGN9H 2 pcs

Aluminum alloy protractor 1 pc

MT300 single quick release pin 3*20 1 pc

Bushing 3.1*5*6 1 pc

Bushing 3.1*5*8 1 pc

accessories (reference) as follows: