Search models, users, collections, and posts
Mountain Bike rectangular top tube cradle for car
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
6.6 h
2 plates
Open in Bambu Studio
Boost
19
38
0
0
25
9
Released
Bill of Materials
Bambu Filaments
Select all
List other parts
- Retrospec Lenox 2-5 - Bike Hitch Rack x 1: https://www.amazon.com/dp/B0923936NH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Description
Bike rack cradle for bikes with rectangular top tubes. This cradle has been designed for a Retrospec Lenox 2-5 - Bike Hitch Rack but would work for any bike rack with 1 inch (25mm) tubes. All of the original hardware from the existing cradle can be transferred to this print, including the captured nut, tensioning bolt and rubber strap. The print is designed to not need supports. Since this print will be exposed to weather conditions and prolonged stress on the tie down posts, it is recommended to use nylon or other suitable filaments. It also includes raised inserts that are intended to be printed in TPU.
The bike rack used for testing can be found here: https://www.amazon.com/dp/B0923936NH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)