Search models, users, collections, and posts
LCR-T4 enclosure with battery clip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.2 h
3 plates
Open in Bambu Studio
Boost
21
36
7
8
81
43
Released
Description
Another enclosure for the LCR-T4 component tester.
I designed this one because I couldn't find one to fit my needs.
There is a battery clip to make battery swap easy.
The top part fit's the bottom part snug, but you can use some superglue if needed (my print didn't need superglue)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (7)