1-1: Some users experienced issues with the front cover not closing properly. Research showed this was due to elephant foot deformation in certain filaments, so elephant foot compensation has been added. Model data remains unchanged.
3-1, 3-2, 3-3, 3-4, 3-5, 3-6: Some users encountered issues with gears not rolling smoothly, also caused by filament shrinkage. Tolerance has been increased to allow for greater movement.
5-2, 5-6: Fixed a bug where a small corner did not touch the base plate.
Added 5-9: Lens case light-shielding part, which effectively improves ghosting issues in imaging.
Note: For easy disassembly, please use double-sided tape instead of super glue when installing the flash on the middle casing.
September 7th Update Notes:
Middle casing with new button and latchFront casing with new locking and unlocking functions
1-1, 1-2, 1-3, 1-4, 1-5, 1-6, 3-1, 3-3, 3-4, 3-6, 3-11, 3-15, 3-16, 3-17: The photo paper roller now has locking and unlocking functions, perfectly solving the problem of photo paper not feeding into the roller. Part 1-1's printing orientation was adjusted, significantly reducing supports. The front cover can now be opened with a button, resolving the previous issue where excessive joystick resistance caused the front cover to open.
2-2, 2-3: Thickened, no longer easily broken.
Thanks to He Tongxue for the idea
August 30th Update Notes:
2-2, 2-3, 2-4, 4-7, 4-8, 4-9: The bottom cover has been completely updated, now with a higher degree of assembly.
1-1, 3-1, 3-6, 3-10, 3-12, 3-14: The front cover structure has been reinforced overall, making it more robust. There is now no noticeable gap between the front cover and the main body. Added auxiliary tie-wrap holes for front cover installation. Adjusted spring tension for more even photo paper chemical application.
4-3: Fine-tuned dimensions for a tighter fit.
5-2: Fine-tuned dimensions for easier photo paper cartridge installation.
5-5: Adjusted the photo paper pushing mechanism for a higher success rate in pushing photo paper.
August 18th Update Notes: Fixed a critical bug in model 1-1, and addressed dimension issues in some models on plates three and four
Hardware components:
M3*14 flat head hex screws x8
M3 nuts x8
8*100mm stainless steel smooth shafts x2
0.7*7*10 spring steel compression springs x9
M3*3 flat end set hex screws x2
1/4 inch camera tripod specific M6 coarse thread nut x1
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)