H2S, H2D Poop Chute - 2.0 Version, collects into plastic bags, convenient for large quantities

Latest update on Dec 11th, 2.0 version:

Modified the transition structure, changed from internal embed to external package with internal embed hybrid, thickened the outlet to prevent waste from getting stuck at the transition joints and inside the pipe.

Thanks to the support from a few friends. Originally, when I found the filament getting stuck, I thought it was still usable, just needed to clear it occasionally. But your support made me overcome my laziness and modify and improve this model!

A good model always requires continuous improvement and refinement. A small boost is your greatest affirmation of me! Thanks again!

Waste collection accessories made for H2 series printers

My newly bought H2S doesn't have a waste bin, but I'm too lazy... The poop chutes designed by other users require manually emptying the waste, which I feel isn't suitable for me 😅😅😅

I only like plastic bags, directly to the trash can...🚮

So, I modeled and designed a waste slide that suits me.

Design Details:

1️⃣As long as your bag is large enough, you can clean it once in a long while!

2️⃣Once the bag is full, just take it off and throw it away!

3️⃣No need to worry about waste burning the bag; there's a buffer to hold the waste, and the next piece of waste will push it down.

4️⃣No need to worry about heat dissipation holes; the outlet is angled to avoid them, and the wind will also blow the plastic bag open, preventing poor heat dissipation.

5️⃣If the bag's handles are long, you can wrap them a few more times around the hooks; I've left enough height for the hooks.

Overall, this poop chute is quite practical, hahaha~~~

Installation Instructions:

Install using this screw on the printer body; no need to worry, this screw is not connected to any critical part of the printer.

You can also print my exhaust duct; I have been using it for a long time, it's really quiet, and it can completely vent out those strange smells!