Handheld weapons for figure models

Recently I printed a skeleton model, and the quality is quite good, https://makerworld.com.cn/zh/models/244112-ku-lou-tao-qia-tinkercad#profileId-181574.

I specially made a stick weapon for it. Also sharing a scythe model for it.

The models are slightly elliptical, convenient for assembly and disassembly.

Suggestions are as follows:

Note that there are three plates, you can first print the stick of the shortest hammer (lollipop) from the second plate, test if the tolerance fits into the skeleton, and then print completely. If your tolerance is not suitable, you can appropriately scale up by 0.01 or scale down by 0.01.

Of course, if it's just for pure printing, you can print it as you like.