H2D & H2S poop chute+4 buckets (no magnets & glue)

i made this design to not use any magnets or glue or extra screws. 

update 12,11,2025:V2.1

uses less material and prints faster , and increases the velocity of poop s comin down slightly , resulting in less possible clogs .

update 12,10,2025: V2

now the purges will slide down at a highr angle so the chances of them being stock at the end of the slope reduces for heavy purges.

also added a border at the bottom to prevent thin purges get stuck in the ventilation mesh .

• the poop chute is safe for the printer ventilation system as it has mesh to not cover the vents
• also its raised up to not cover all the vent .

• its curved so even if you have a tiny space on the side you can use it perfectly.

   

• the buckets are diffrent sizes based on your needs .
• also there is a handle for the bucket to be carried on easily .
• there is an H2S only bucket as well to use all the built plate for a longer bucket .

what you need :

already included with the printer , screws for spool holder.