Search models, users, collections, and posts
Simple GPU Holder
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
8 h
3 plates
Open in Bambu Studio
Boost
3
5
0
0
11
4
Released
Description
Simple design for a gpu holder, two versions "big" and "normal", screw part is interchangeable - any will screw into any size (only the body and length differ, screw size and pitch is same) so you can use small body and 120mm big screw. PLA should work but I advise PETG. FreeCAD sources included
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)