Search models, users, collections, and posts
Caution Hot Water Sign
IP Report
This model is created by Make My Sign
Make Your Model
Print Profile(2)
Smaller Sizes signs scaled down by (85%,75%,65%,55%,50%)
Designer
5.5 h
6 plates
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
9
7
1
1
28
9
Released
Description
I made this using the Make the Sign tool on MakerWorld.
Since I couldn’t find this type of sign anywhere, I created it myself for the office where I work, as it was needed there.
The sign is 6 mm thick, which not only provides strength and sturdiness but also ensures the design prints correctly. At this thickness, the black layer remains visible; if it were any thinner, the black areas would not show properly, and the sign would appear as a single colour.
Boost Me (for free)
Any and all boosts are greatly appreciated. Thank you!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)