Anbernic RG34XX Case

I recently got my hands on an Anbernic RG34XX (which is the same in size as a Nintendo GameBoy Advance / GBA as far as I know). As for all of my handhelds, I wanted to have a case for it, so I can throw it in my backpack without needing to worry about it getting damaged. As this device already seemed very tanky to me, I decided to go for a as slim as possible box, but while keeping my minimal protection standards (completely enclosed, additional protection to the front). And because of the curved back of the device, I kept the box' bottom part flat rather than perfectly fit, so you can tap one side of the device to lift it up and easily get it out of the case.

Also I decided to make this usable with the original foam padding that comes with the device for everyone who can't print TPU. So you now got a few options here:

1. use the original foam padding from the packaging the device came in
2. print the TPU padding that comes with the print profile (plate 3)
3. download the scan of the original padding and use it as a stencil to cut a fitting piece yourself (the TPU part and the original piece have a thickness of 3.4mm)

The case itself then gets assembled using 4x 30mm M3 screws and some glue or double sided adhesive tape to glue in the screen protection.