Desktop multi-layer stackable storage basket for desk, office workstation, small sundries, snacks, and documents

2026-1-18

This is now version 3.0, mainly optimizing the stacking structure to make supports very easy to remove Of course, it's also fine if you don't use supports

Because the stacking structure of this version has changed significantly, it cannot be stacked with older versions, so I had to create a new post You can find it by clicking the link below

3.0 Optimized Version - Desktop Multi-Layer Stackable Organizer for Desk, Office, Workstation, Small Items, Snacks, File Storage Basket - Free 3D Printed Model - MakerWorld

As for this old version, it will no longer be updated in principle Thank you all for your support

-------------------------------------------------------------------------------------------------------------------------------------------------------------

2025-12-27

At the request of netizens, an extra-large version has been added, which can accommodate A4 paper (not just a simple enlargement) However, only H2 series machines can print it due to its large size Since I don't have these machines, I can't test it for everyone Only those who truly need it can print and test it themselves

Another heads-up: I'm currently working on modifying the model, hoping to make it support-free after the changes

------------------------------------------------------------------------------------------------------------------------------------------

2025-12-21

At the request of netizens, a "solid version" has been added However, the exact increase in load-bearing capacity of this solid version has not been tested I look forward to everyone's feedback

Also, some netizens previously reported that supports were difficult to remove I've tested this recently and found that the ease of support removal depends on the filament used For example, with the same settings, Yu Brothers' PETG HF is relatively difficult to remove, while Dajian's PETG is easier The easiest to remove is the official PETG HF

-----------------------------------------------------------------------------------------

2025-11-11

Adjusted the support tuning, hoping to solve the problem some friends mentioned about "the sides being a bit soft and collapsing" Friends experiencing this issue can try the "Support Settings Adjustment 2.0" print profile

————————————————————————————————

2025-11-8

Added a lid for the small organizer, so now you can put things on top of the small one Below are actual photos:

---------------------------------------------------------------

A stackable, multi-layer desktop organizer

Available in two sizes: large and small

Large size

Small size

Multiple units stacked together

Below are actual photos