Search models, users, collections, and posts
Hek lok: A print-in-place belt clip(Tek-lok clone)
IP Report
Print Profile(4)
PLA 0.2mm layer, 6 walls, 15% infill
Designer
1.4 h
1 plate
PETG 0.2mm layer, 6 walls, 15% infill
Designer
1.6 h
1 plate
ABS 0.2mm layer, 6 walls, 15% infill
Designer
1.3 h
1 plate
0.2mm layer, 8 walls, 100% infill
2.8 h
1 plate
Open in Bambu Studio
Boost
105
291
37
22
358
215
Released
Description
This style belt clip is often used for attaching tools, knives, and other accessories to belts of various sizes.
The hek lok requires no hardware to attach to the belt, but can use standard tek-lok hardware or M5 nuts/bolts to attach various items to the clip.
Print instructions:
PETG is an ideal material for the repeated flex of the clip, though PLA+ also works fine.
Recommended to use at least 2.4mm of walls (6 perimeters @0.4mm width) so that the clip arms print as continuous lines, though as few as 4 walls may work.
Paint on supports are required at the two downward facing surfaces of the clip hooks as shown below. Recommended to use smart fill to paint the entire surface.
Tech lock tec loc teck lok
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (37)