Search models, users, collections, and posts
Skadis Wire Brush Holder
Remixed by
IP Report
Print Profile(2)
Wire Brush Holder Without Lettering - 0.2mm layer, 6 walls, 25% infill
Designer
54 min
1 plate
Wire Brush Holder With Lettering - 0.2mm layer, 6 walls, 25% infill
Designer
54 min
1 plate
Open in Bambu Studio
Boost
246
834
119
9
896
651
Released
Description
This is a wire brush holder for the Ikea Skadis peg board. It has a spot for the nylon, copper and steel brushes that come in most sets. I have included both a labeled and non-labeled version. It utilises the Ikea Skadis Universal Hook mounting system so no supports should be required.
The opening is 7.5mm wide (may vary based on your printer's tolerances), please consider this when determining if your brushes will fit.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (119)