Knipex Pliers Holder Element System Pegboard

Knipex Pliers Holder for an Element System pegboard.

There are two different holders, one version is for small electronics pliers (115 or 125mm) and one version for medium-sized electrician's pliers such as side cutters or combination pliers with a length of approx 140mm. A holder accommodates a different number of pliers, depending on how large or wide the pliers are. The holders certainly work with pliers from other manufacturers too, but I have only tried them with Knipex pliers.

Any number of holders can be arranged directly next to each other or with some spacing.

For easy removal and to optimize space on the pegboard, the receptacles are arranged at a 45-degree angle. In addition, there is a small storage compartment at the back of the holder to make good use of the necessary spacing.

The model can be printed with different materials, minimal support is necessary.

Due to the geometry of the model, it may tend to warp slightly at the beginning of the print, so good bed adhesion should be ensured. A 5mm brim is already provided, and increasing the bed temperature by 5-10 degrees can also be helpful.

Also check out my other matching model:

Screwdriver Holder Element System

Screwdriver Bit Holder Element System

More holders for Element System will follow.

You don't have an Element pegboard, but one from Küpper or Ikea?

Also check out my other holders for Küpper and Ikea pegboards.

Have fun printing!