Woodworking 3/4" Pipe Clamp Risers Leveling Stands

These risers are designed to lift standard 3/4" pipe clamps off your work surface during glue-ups. If you use multiple brands of pipe clamps (Pony, Bessey, Jorgensen, Harbor Freight, etc.), you’ve probably noticed they don’t all sit at the same height. These blocks level the clamps and prevent rocking, sliding, or contact with wet glue.

✔ Features

• Fits most 3/4" pipe clamps
• Raises clamps off the bench to protect the surface
• Levels mixed-brand clamps to a consistent height
• Provides a stable base during glue-ups
• Prints without supports and with minimal material

✔ Recommended Print Settings

• Material: Your choice but I do recommend PETG as it is slightly flexible to make snap-fit better.
• Layer Height: 0.2 mm
• Infill: 10-15%
• Perimeters: 3 walls
• Supports: Not required
• Orientation: Recommend broad side down as in the print profile.

✔ Use Case

Great for woodworking glue-ups on tables, assembly benches, or torsion boxes. Keeps clamps steady. Easily snap on and off.

✔ Notes

You can print as many as needed based on how many clamps you typically run at once. For longer glue-ups, pairs or sets of 4+ work best.