3D Printed Remote Control Rubber Band Airplane Model

This is a scaled-up remote control aircraft! I believe you must have thought that the rubber band planes you played with as a child always needed to be wound many times to take off, and the flight distance was not very optimistic, and the worst part was that you couldn't control the direction! To realize my childhood dream, I made it today. The overall weight is very light, and the wind resistance is very strong, and it can glide and land. It is very suitable for friends who want to get started with model aircraft or like 3D printing. However, before assembly, you need to pay attention to some issues. That is, the parts that have been glued need to be left for 24 hours before high-intensity flight. For printing filament, we recommend using PLA Aero! Although one kilogram is a bit expensive, being able to print two such aircraft is truly perfect! Of course, you can also use PLA filament, but the weight will be slightly heavier, and the overall strength will be relatively brittle. Theoretically, if there is enough power, it can also take off successfully. Before printing, please note: Be sure to calibrate the machine and test the flow rate, this is very important! All parameters in Bambu Studio have been set, and you can also adjust them according to your printing habits! In addition, before using PLA Aero, be sure to dry it! Be sure to dry it! Be sure to dry it! I have made a table of the assembly process and the required parts and put it in the document. Interested friends are welcome to check it out! If you find this helpful, don't forget to boost me so that more dream-loving friends can see it!