Search models, users, collections, and posts
Assassins teapot
IP Report
Print Profile(3)
WITH SUPPORTS
Designer
6.1 h
2 plates
Two plates, NO SUPPORTS
Designer
5.3 h
2 plates
0.2mm layer, 3 walls, 15% infill
Designer
4.9 h
1 plate
Open in Bambu Studio
Boost
158
311
49
8
565
239
Released
Description
Works well and the kids love it.
I printed this with no supports without any issues. I specifically tried to design the breather hole to avoid supports. The printer should have no issues bridging the gap.
I did apply some wood wax oil with a small paintbrush to the bottom compartment DURING PRINT to make the teapot water tight. Not sure it's needed, but I had wax laying around and decided I'd try it and it's not leaking :)
It's also possible to add a liquid sealant post print!
As you can see in the pic, the fluids are visible through the PLA, maybe try increasing to three walls or print in darker colors. I ended up spray-painting this print.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (49)