Scorpion Mortal Kombat Hueforge

“Get over here!”

This Hueforge artwork captures the legendary Scorpion in striking detail, surrounded by blazing flames. The layered shading in greys and blacks makes his hooded armour pop, while the fiery orange glow brings the piece to life.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x150mm in size
You may print at higher layer heights below the Base Thickness of 0.8mm
The Max allowed Thickness is 2.32mm and the Actual Thickness is 2.32mm

Filaments Used:
    #000000 PLA+ Sunlu Black  Transmission Distance: 0.6
    #ffffff PLA+ Sunlu White  Transmission Distance: 8.5
    #ff8000 PLA+ Sunlu Orange  Transmission Distance: 5
    #f0be02 PLA PolyTerra Savannah Yellow  Transmission Distance: 3.5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #11 (0.96mm) swap to White
    At layer #17 (1.44mm) swap to Orange
    At layer #24 (2mm) swap to Savannah Yellow for the rest.

Remember if you want to resize then make sure you only change the X and Y (make sure the Z stays the same as changing this will affect how the print turns out)