Fractal Ridge: screwable GPU anti-sag bracket

This GPU bracket prevents sagging to either direction in the Fractal Design Ridge PC case. It's made especially for the Asus Prime RX 9070 XT, but it might work with other cards if the screw hole height is similar.

You'll need an M3 screw to fasten it into your GPU's support bracket screw hole. I used an M3 x 10mm, but I believe ~6mm would be enough.

There's a print profile with plates/variants for both countersunk and non-countersunk screw heads, as well as step files.

While small differences shouldn't cause issues, I recommend you set up your filament settings so it accounts for shrinkage —and particularly if you'll be annealing the part, as many filaments may shrink a couple mm.

Finally, remember that this part will be exposed to your GPU's and other components' heat, so make sure you use a heat-resistant filament. I used Polymaker's HT-PLA-GF.