Hollow Knight - Sword Drawing Stance (No AMS needed, with base, rotatable head version)

Hello everyone! This time I'm bringing you a character from the game Hollow Knight. I personally love this design, so I made this model and am sharing it with everyone.

For the skin part, dark green or dark gray would be more suitable. Since I don't currently have these two colors, I used blue, but the effect is still acceptable.

It's still designed with separate parts, so no AMS is needed. Installation is still very simple, but special attention is needed for the weapon part: When printing only one sword per plate, the sword tip comes out very poorly as shown in Figure 1 (I tried 3 times with the same bad result), but when printing four swords on one plate, the sword tips can be printed normally as shown in Figure 2 (although not perfect in the image, it's clear the stringing is due to damp filament). I can't explain this situation, so I hope any experienced users can comment and share the reason.

Another thing to note is that for printing the cloak part, you need to enable the raft layer in the support settings. It's enabled by default, but if you turn it off, the print will fail (I've tried and failed 4 times).

Finally, if you like my model, please like, follow, download, and boost to support my work. If there are any models you'd like, you can also try leaving a comment, and I'll arrange it as appropriate ^_^